Sony SRF-QT1 Radio User Manual

The Sony SRF-QT1 is a compact, portable AM/FM radio featuring a built-in speaker, headphone jack, telescopic antenna, digital tuning with preset stations, LCD display with backlight, and battery-powered operation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Using the Radio 8. Accessibility Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: LCD display, telescopic antenna, built-in speaker, headphone jack, control buttons, battery compartment.

Feature	Description
Telescopic antenna	For improved AM/FM reception
LCD display with backlight	Shows frequency, time, and station information
Built-in speaker	For audio playback without headphones
Headphone jack (3.5mm)	For private listening
Digital tuning	Precise station selection with auto-scan
Preset stations	Store up to 10 favorite AM/FM stations
Battery compartment	Holds 2 AA batteries for portable operation
POWER button	Turns radio on/off
VOLUME buttons	Adjusts audio level
TUNING buttons	Manual frequency adjustment

Installation

Unpack and inspect contents. Place on stable surface or use as portable device.

Install batteries: Open battery compartment, insert 2 AA batteries observing correct polarity.
Extend antenna: Pull telescopic antenna fully out for best reception.
Connect headphones: Plug into 3.5mm jack if desired.
Power on: Press POWER button to turn on radio.

WARNING! Use correct battery type; do not mix old and new batteries. Keep away from water.

First-Time Setup

Power on radio; follow these initial setup steps.

Select band: Press BAND button to choose between AM and FM.
Auto-scan stations: Press and hold TUNING UP button to scan and stop at first clear station.
Set time: Press CLOCK button, use TUNING buttons to set correct time.
Save presets: Tune to desired station, press and hold a numbered button (1-5) for 2 seconds.

CAUTION! Ensure batteries are properly installed to prevent leakage.

Specifications

Frequency Range: FM: 87.5-108 MHz, AM: 530-1710 kHz.
Tuning System: Digital PLL synthesizer.
Speaker: Built-in dynamic speaker.
Output Power: 100 mW maximum.
Headphone Jack: 3.5mm stereo.
Power Source: 2 AA batteries (DC 3V).
Battery Life: Approximately 50 hours (backlight off).
Dimensions: Approx. 120mm (W) x 70mm (H) x 25mm (D).
Weight: Approx. 150g (without batteries).

Controls and Settings

Access functions via front panel buttons. LCD display shows current status.

Front Panel: POWER, BAND, TUNING UP/DOWN, VOLUME UP/DOWN, PRESET 1-5, CLOCK, LIGHT.

Tuning: Manual with TUNING buttons or auto-scan by holding TUNING UP. Volume: Adjust with VOLUME buttons. Presets: Store and recall up to 5 stations per band. Clock: Set time with CLOCK and TUNING buttons. Display: Press LIGHT to illuminate LCD for 5 seconds.

Connecting Devices

Headphones: Standard 3.5mm stereo plug. External antenna: Not supported; use telescopic antenna only.

Turn radio off before connecting headphones.
Insert headphone plug fully into jack.
Adjust volume to comfortable level when using headphones.

Tip: Using headphones may improve reception in some environments.

Using the Radio

Basic operation for AM/FM listening.

Power on: Press POWER button.
Select band: Press BAND to toggle between AM and FM.
Tune station: Use TUNING buttons or auto-scan.
Adjust volume: Use VOLUME buttons.
Save preset: Tune to station, hold PRESET button (1-5) for 2 seconds.
Recall preset: Press corresponding PRESET button briefly.
Use clock: Press CLOCK to view time; hold to set.
Backlight: Press LIGHT to illuminate display.

WARNING! Do not expose to extreme temperatures; may affect battery life and performance.

Accessibility Features

Tactile buttons: Raised markings for easy identification. Audio feedback: Distinct beep when buttons pressed. Large display: Clear LCD with adjustable viewing angle.

Care & Cleaning

Remove batteries before cleaning. Use soft, dry cloth only; no liquids or chemicals.

CAUTION! Do not use abrasive cleaners; avoid getting moisture in openings.

Regulatory Information

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power	Dead batteries	Replace with fresh AA batteries; check polarity.
Poor reception	Antenna position	Extend antenna fully; reposition radio; move away from obstacles.
No sound from speaker	Volume/mute	Increase volume; check if headphones are plugged in.
Display dim or blank	Backlight/batteries	Press LIGHT button; replace batteries if weak.
Presets not saved	Button press time	Hold PRESET button for full 2 seconds until beep confirms.
Clock reset	Battery removal	Set time again after battery replacement.

Reset: Remove batteries for 1 minute to reset all settings.

Service: 1-800-222-7669; www.sony.com/electronics/support