Sony ICF-SW600 Radio User Manual

The Sony ICF-SW600 is a world-band shortwave radio receiver featuring AM/FM/SW reception, digital tuning with PLL synthesizer, 100 memory presets, direct frequency input, LCD display with backlight, clock with alarm and sleep timer, telescopic antenna, external antenna jack, line-out/headphone jack, and battery/AC power operation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Main unit with LCD display, telescopic antenna, AC adapter, carrying case, user manual.

Installation

Unpack and inspect contents. Place on stable surface.

1. Install batteries: Open battery compartment, insert 4 AA batteries observing polarity.
2. Extend antenna: Fully extend telescopic antenna for best reception.
3. Connect AC adapter: Plug optional AC adapter into DC IN jack and wall outlet.
4. Connect headphones: Plug into headphone jack for private listening.

WARNING! Use correct battery polarity to avoid damage. Do not mix old and new batteries.

First-Time Setup

Power on radio; follow initial setup steps.

1. Set time: Press CLOCK button, use number keys to enter current time.
2. Select band: Press BAND button to choose FM, AM, or SW.
3. Tune stations: Use TUNING buttons or direct frequency entry.
4. Store presets: Tune to station, press MEMORY, then preset number.

CAUTION! Keep away from strong magnetic fields and excessive heat.

Specifications

• Bands: FM, AM, Shortwave (SW).
• Tuning: Digital PLL synthesizer.
• Memory: 100 presets.
• Power: 4 x AA batteries or DC 6V adapter.
• Output: 300 mW into 8 ohms.
• Headphone Jack: 3.5 mm stereo.
• Dimensions: Approx. 180 x 110 x 35 mm.
• Weight: Approx. 450 g (without batteries).
• Operating Temp: 0°C to 40°C.

Controls and Settings

Front Panel: POWER, BAND, TUNING, NUMBER keys, MEMORY, CLOCK, ALARM, SLEEP, BACKLIGHT.

Functions: Direct frequency entry, auto scan, manual fine tuning, memory store/recall.

Clock: Set time, alarm (radio or buzzer), sleep timer (15-90 min). Display: Backlight (press LIGHT). Audio: Volume control, tone switch (normal/wide).

Connecting External Devices

External antenna: Use jack for improved SW reception. Headphones: 3.5 mm plug. Recording: Line-out to recorder.

1. Turn off radio before connecting external devices.
2. For external antenna, plug into EXT ANT jack.
3. For headphones, insert plug into headphone jack.
4. For recording, connect line-out to recorder input.

Tip: Use external antenna for better shortwave reception, especially indoors.

Operating Modes

Supports FM stereo, AM, and shortwave bands.

1. Power on: Press POWER button.
2. Select band: Press BAND to cycle FM/AM/SW.
3. Tune: Use TUNING buttons or enter frequency directly.
4. Adjust volume: Turn VOLUME knob.
5. Use scan: Press and hold TUNING for auto scan.
6. Set alarm: Press ALARM, set time and source (radio/buzzer).
7. Sleep timer: Press SLEEP repeatedly for 15-90 min.
8. Backlight: Press LIGHT to illuminate display.

WARNING! Do not expose to water or extreme temperatures.

Memory Functions

Store up to 100 stations across all bands.

1. Tune to desired station.
2. Press MEMORY button.
3. Press two-digit number (00-99) using number keys.
4. Recall: Press MEMORY, then preset number.
5. Clear: Store another frequency over existing preset.

Note: Memory is retained when batteries are removed (backup capacitor).

Care & Cleaning

Remove batteries before cleaning. Use soft, dry cloth only; no solvents or abrasives.

CAUTION! Do not use chemicals; keep away from moisture and dust.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. Copyright © Sony Corporation. For support, visit www.sony.com/electronics/support or contact 1-800-222-7669.

Troubleshooting

Reset: Remove batteries for 30 seconds to reset microprocessor.

Service: 1-800-222-7669; www.sony.com/electronics/support